Cummins 4BT & Diesel Conversions Forums banner

Swap for 2.8L VM CRD Liberty

5K views 1 reply 2 participants last post by  cRiPpLe_rOoStEr 
#1 ·
I have a 2005 Jeep Liberty with a blown 2.8L VM CRD (R428). I have two questions for the board:

1. Will a 2.8L VM CRD (R428) from a European Chrysler Voyager fit, ie bolt patterns and engine mounts?
2. Are there any good swaps if I'm unable to locate a reasonably priced 2.8L?

Thanks!
 
#2 ·
1. i'm just not sure about the bolt pattern to be exactly the same, but the mounts are closely the same...

2. reasonable alternatives can be the 5-cyl mercedes engines that was used in the sprinter, or a v6 from audi, unless you could overcome the smog patrol and slap a b3.3
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top