Forum: General Modification Discussion (Non-Engine)

look this blazer......... http://www.youtube.com/watch?v=bZrpb3N4m98 would something like this be street-legal in the u.s.?

has anybody here tried to use motorcycle-type stators bolted directly into the crankshaft instead of using a belt-driven alternator? i've already...

so the last few days my jeep has been acting very strange. when im driving with no electronics on, besides injection pump, the volt meter is in the...

I know that I have seen them but I can't recall in what?

New here so not sure of the best place to put this. I've got a GMC bread truck with the 4bt swap, a utilimaster its a 91. I lost the clutch in...

i want to build rock sliders for my 95 ram 2500,only thing stopping me right now, is wether to weld then onto the frame or to make up brackets and...

I have a Clarke interment tach/rpm counter off a '70? freight liner it is a cable drive, will it work with my 4BTA?

I have a 97 Dodge 2500 4x4 diesel. Replacing bearing hsg. There are four bolts in housing .I think they are 12 pt 15 mm. Someone thought they might...

Hi: Doing a 4bt to a F150 swap. using a AOD non-e trans. gonna ditch the ecu. Is there a way to keep my stock gauges after losing the factory...

i have a 90 f150 4x4 5 speed with a/c with the 6bt cummins im thinkin bout runnin the banks intercooler techni cooler part number is B7625977 im not...

I know this is a stupid question but sometimes you just need reassuring. I need to run a wire from my battery to the fuse box and to the...

I've got a 54 Dodge M37 I'm converting to my daily driver/wheeler. The first thing I noticed is that after 15 minutes driving at anything greater...

so i installed the ford hydroboost from my step van in my yj thats getting the 4bta. do i need to do anything to my steering box with the new...

so the 4bt out of the step van didnt have a tach, can i rig my jeep yj tach up to this motor?

Seriously? general modification??? Do you guys realize almost everything on my truck is modded in a major way? The only thing even remotely stock...

Anyone have any advise for a guy looking to buy a winch for the first time? Specifically what options, brands, etc. to look out for? Looking to buy...

I've got a line on a Dodge Ram hydroboost set-up but see that it has separate reservoirs and what appears to be multiple lines, I assume for the ABS....

need help on heater wire in switch....dash apart on yj wrangler...got schematics or any info?

No Limit Engineering has introduced a new truck chassis for '47-59 Chevy and '48-'60 Ford trucks. The rolling chassis is priced at about $11,000...