I just made the rad hoses for my Jeep yesterday, go to your local parts store and ask if you can go back and look at the hoses, measure connection sizes first, and approx measurements you will need.
The top hose is Autozone number 61252 (I think it is also a Goodyear number too). Fit after trimming a couple inches off the rad end. Engine side is 1.75" ID, rad 1.5" ID.
Lower hose is comprised of two hoses number 61323 is on the engine side (2.25" ID), reduced to 2"). The rad side hose is number 61252 (1.75" ID on each end).
The local plumbing shop hooked up up with a street elbow and reducer which I soldered together, BTW, copper is not cheap $21 for the two pieces.
Wolf,
If your setup is the same as mine, 1977 C/10 then the hoses should be:
Gates Hoses #'s Upper Hose #21729 and Lower # 21731
Hope this helps.
Chuck
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Cummins 4BT & Diesel Conversions Forums
375.9K posts
53K members
Since 2007
A forum community dedicated to Cummins 4BT Diesel owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, engine swaps, transfer cases, and more!