I decided to start a thread devoted to this trans for a couple reasons. First off, there is a LOT, and I mean a LOT of misinformation out there. Second, there is little useful info for some basic specifications on these transmissions. Finally, a lot of guys think they are too complicated or too...

Ok, so there seems to be a ton of misinformation out there regarding the TDI motors and swapping them. I'm here to set this straight! I own a TDI specialty shop and have been working/modifying/swapping them for 7 years now. I've been there and done that with just about every avenue regarding...

Here is my latest project... A '69 Toyota Land Cruiser wagon, with a 1990 105hp 4BT VE Bosch Rotary Pump, NV5600 6 speed from Dodge '04, Dana 300, on a '93 FZJ80 Toyota Land Cruiser coil sprung frame/axles/chassis. This is actually the second time I have built this truck.. The first one got a...

Hey everyone, I was wondering if anyone had any engine suggestions for a 2006 Ford F150 (Extended Cab, 6.5 Bed, have a 5.4 now). My 5.4 has 180k miles on it and I think it is rounding the corner to the end of its life. So I'm looking at swapping a diesel in. So far I have looked at a 4.5 V6...

Introduction I have been planning this swap for 4 years now. I have been collecting parts since then. So far I have all of the large parts 1. 120hp 4bta 2. Ford adapter plate 3. small block ZF5 4. NP205 transfer case 5. 97 Explorer 8.8 rear axle 3.73 posi. (yay!, no drum brakes) 6. Set of 33"...