Cummins 4BT & Diesel Conversions Forums banner

manual

  1. Isuzu 4BD1T/2T
    Hi all - newb here on the Isuzus (but been turning a wrench for like 30 years on about everything else-I'm on MANY other gear-head internet forums too) and First, I want to say thanks for the forum here! It helped me diagnose and repair the glow plug system on a 1993 NPR with the 4BD1T engine...
  2. Vehicles For Sale
    Putting my project up for sale. Just don't have time or money right now to finish it. A very solid build, about 80% finished. Below are links to my build thread and Craigslist AD. Pictures in the CL Ad are a little outdated, I will update soon. Price is $9800. Well over $12k invested...
  3. Transmission, Adapter, Transfercase Discussion
    Okay, so I'm doing research into a 6BT swap into a '65 - '67 Lincoln Continental and before i start the project, I want to have all the foreseen needed parts. So my question is this; if I swap a 6BT into the Continental, what would be the best transmission to use? I would prefer a manual, since...
  4. Want to Buy
    Hello, I am looking for the following service manuals for a NV4500 five speed #17003.13-1A and 17003.13-2 that were part of a course. Below is a picture of the manuals. If you have them please shoot me a PM. Thanks!
  5. Want to Buy
    Looking for 1989 / 1990 /1991 Isuzu box truck with a 4BD1T diesel engine , 18 ft box or larger , 5 speed manual tranny. Looking for a good running engine. I am located in CT. Any help would be appreciated.
  6. Transmission, Adapter, Transfercase Discussion
    I happened to have a pair of Ford manual transmissions sitting side by side in my shop so I snapped a few pictures for reference. The trans on the left is a ZF (smallblock bellhousing) and the one on the right is a Ford-Mazda M5OD (or M5R2). Aside from being much "beefier", the ZF seems to be...
  7. General Classifieds
    have Two ZF s542 5 speed transmissions from Ford-F-150 1/2 ton truck this is for the ford small block Adapter plate, One is recently rebuilt One is a core that has all the parts and could be used after a rebuild. only issue was the rear mount bolt hole was cracked but was fixed I am asking...
  8. General Classifieds
    FORD complete adapter Used Ford adapter set is in great condition. Includes; Cummins to Ford adapter plate, starter spacer, flywheel, hydraulic master/slave cylinder and lines, Ford manual bell housing, clutch, pressure plate, clutch pedal and bracket, and bearings. Will work with Cummins 4bt...
  9. Misc Stuff For Sale
    NV4500 with all parts for conversion. Namely clutch petal, bellhousing, fork, throw out bearing, master and slave cylinder, and the lines. Its the chevy 93 with the low first gear!:grinpimp: I am asking 1300 OBO:smokin:
Top