Cummins 4BT & Diesel Conversions Forums banner
21 - 21 of 21 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #21 ·
I see this as three point mount with two cushions on front mount. Have seen this setup used on older GMC 6V53 and 6-71 trucks.

My concern would have been the offset between engine and frame mounts. I would have remedy this by moving the left frame cushion right so it center lines with the engine.

Bob G in Virginia
Bob, I see what you mean. It flat didn't occur to me. I don't think it'll be a problem, though. I'll probably run the thing as it is until spring and then start fine tuning and getting ready for paint.
 
21 - 21 of 21 Posts
Top