Cummins 4BT & Diesel Conversions Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter · #1 ·
getting all my stuff gathered for this fall if all goes well to swap all parts off my donor 91 dodge 4x4 pu to my 78 crew cab dodge. it will be a getrag stick since i have had no issues with my 93. looking to quiet down the tinney interior since that roof sounds like a drum on the road. looking at some interior parts to calm down some of that noise. going to use all the parts of my donor rig. front and rear end , springs. power steering , transfer case and of coarse the 6bt motor. i am all ears for doing this thing so tell me now what is going to horse me up or forever hold your peace. just kidding. any comments welcome.
 

Attachments

·
Administrator
Joined
·
4,200 Posts
Aside from the rear drive shaft situation it will probably be a bolt in installation. Are they both 6 ft or 8 ft beds?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top