Cummins 4BT & Diesel Conversions Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,109 Posts
Discussion Starter #1
can you use a 92 dodge 1/2 ton 5speed from a 360 engine behind a cummins? didn't know if the bellhousing would interchange or not? my friend has one that had an engine fire.
 

·
Registered
Joined
·
187 Posts
if i'm correct, the bellhousing won't fit, but you can use the tranny as long as you get the first gen cummins bell crank adapter.
 

·
Registered
Joined
·
1,203 Posts
that should be an NV3550. Adapting it would be similar to adapting a AX15, i know at least one or two have done that on this forum, but i don't know too much about doing it.
 

·
Registered
Joined
·
187 Posts
Yes, the bellhousing and flywheel from a first gen, and you may or may not need a custom spacer/new input shaft depending if the shaft is too long/short for the stock adapter - I'm not familiar with the lengths of the 3550. I've seen it done in pictures, so it must be possible!

Stupid question, but have you Google'd it? Someone must have a write-up on it.
 
1 - 5 of 5 Posts
Top