Cummins 4BT & Diesel Conversions Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
First post for a new guy, so hello and thank you in advance. I have finally decided to break down and try my hand at a diesel conversion on a 76 J-20 pickup that I have had for sometime.
For the swap I am leaning towards a vt275 v-6, but have some concerns over doing an install that requires wiring an ecm into the truck. Anybody have any experience with one of these motors
or wiring an ecm into a vehicle? It seems as easy as connecting the control unit and getting power to it, but I would hate to think that it was that easy and then be up the creek in a month when
I cant figure out how to properly install the harness. Any help would be great, Thank again.
 
1 - 1 of 1 Posts
Top