Cummins 4BT & Diesel Conversions Forums banner
1 - 1 of 1 Posts

·
Banned
Joined
·
2,733 Posts
or should i just have a muck around with the position of the trans rear mount ? any help would be much appreciated.
If you do, your driveline will not be parallel with the framerails, hard on U-joints. Unless you recenter rear diff $$$ Had same problem with EFB wanted to move engine 2" pass side to clear NP205 but bellhousing was 3/4" from framerail already.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top