[Crusty Nut]

Has anyone used this fitting?
http://store.summitracing.com/partdetail.asp?autofilter=1&part=RUS-640281&N=700+115&autoview=sku
It works on GM stuff, but I'm not sure if it will work on a '90 M5R2 trans.
Otherwise, what are you guys doing to adapt away from the black plastic line on the stock setup?
Thanks, Matt

 

[Crusty Nut]

So, what are you guys using for clutch lines? The stock black plastic stuff?

 

[bt4mpg]

I used the stock plastic hose. The 1985 fitting into the clutch master cylinder was a different size than the 1990 fitting. I believe the newer one was bigger.

 

[CrewCab59]

Here is the clutch master line I sell ,post #52 show line at master and at slave .The line has the same fitting that ford and didge use.

This may work for you ?
http://www.4btswaps.com/forum/showthread.php?t=29&page=4&highlight=project+J10