Cummins 4BT & Diesel Conversions Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
71 Posts
I also have an early 5.61 ratio Chevy NV4500. I believe it was dual drilled from Advance Adapters. A 5.61 Chevy input can be changed to the equivalent Dodge.

Pull your current input shaft, count the teeth and call the tranny shop. They can tell you if the Dodge will interchange. I'm confident it will. I believe the Dodge is a 22T. If yours is 22T then they will interchange. You will also need to change the bearing retainer etc. I had the tranny house assemble a new bearing and seal as part of my swap so it was real easy to make the change.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top