Cummins 4BT & Diesel Conversions Forums banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 · (Edited)
I plan on doing a swap on a 1958 chevy apache stepside and I am looking for advice on what transmission and rear end ration to use? Currently I have a 1990 stepvan with a 4bt and a 4speed trans complete and the 1958 with a 350/350 complete. My build is going to be used as a daily driver as I commute 90 miles a day for work. The overall tire diameter is going to be 29 inches. My problem is that i like to drive at about 80 mph to work. What do you think??? automatic or manual and which ones? what gear ratio for the rear?? any help on this build would be great. how do you all feel about a 700r4, I need a rear too but i want to keep it a 6 lug..
I plan on pulling both motors this week.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top