Cummins 4BT & Diesel Conversions Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,230 Posts
Discussion Starter · #1 ·
Okay, i'm finishing up my 4bt project and moving on to my 69 CC f350 with a 4x4 47RH and a 241 DHD. I want to build it right. I'm figuring for the money it would take to go to the 4r100 or 5r110 i can get the 47RH done right and save money.

If you've got experience with building up a 47Rh to make it stand up to towing it would be great for you to share that here. I will be towing camper/boat/ and occasional 15K gooseneck trailer.

I'm not going to be more that 250 HP and I plan to use one of Phil's super single disc torque convertors with a slightly lowered stall.
He suggested a good valve body to get pressures up a bit.

Any recommendations on who to use/or what kit to use for a good VB rebuild?

As far as OD and LU i'm working on a stand alone controller apart from the PCM and pressure switches to control their function- i'll post up more soon on that!

I don't think i need a billet shaft or anything like that, but if you have suggestions on how to's or maybe even which kit to use, please post away.
Lastly, many times you get what you pay for, but i don't want to overspend on something that doesn't have a good return!!!
 

·
Registered
Joined
·
1,230 Posts
Discussion Starter · #6 ·
Thanks Ryan I will pm you later.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top