[WC53]

Yes I understand driveline phasing and what can happen when you run your differentials and engine out of phase . But I want to know what angle the block is running in your rig . Just picking a few brains before I get into setting mine up .

 

[mooktank]

I run a CV driveshaft front and rear...


No such worries.

 

[Paul(in NY)]

Both Carryall and M37, 7 degrees down at the rear.

Paul

 

[WC53]

I thought you had it a 7 degrees.

The clearance with the steering box is going to be an issue . I gather your 4bt is a bit to the passenger side.

 

[mcinfantry]

mine is about 7 degrees down (need to get it on level ground to see)

8 degrees tilted top tiled to pass side (looking from front)

 

[Paul(in NY)]

The clearance with the steering box is going to be an issue . I gather your 4bt is a bit to the passenger side.

My carryall has the engine/tranny/tcase off set 1.625" to the right (passenger) to give needed clearence to the saginaw PS box.

Paul

 

[mcinfantry]

that clearance was why i would not run a dodge setup.

 

[CrewCab59]

Most will be a fit and finished the mock up is what will make it or break it,take your time check and double check.
Each make will be up to you what you think looks best and fits with your set up.

Hope this info helps.

CrewCab59