Cummins 4BT & Diesel Conversions Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
225 Posts
Discussion Starter · #1 ·
After putting my engine back together I had to bleed the air from #1&2 injectors. Some fuel ran down the injector and apparently some compression is leaking just above the big nut on the injector, the fuel was foaming & bubbling. Will this cause some unwanted scoring or can I fix it at my leisure after studying my options? Thanks,
Carl
 

·
Registered
Joined
·
225 Posts
Discussion Starter · #3 ·
:confused: I may not have been clear. When I bled the lines, fuel of course ran down the outside of the injector. This fuel then pooled around the top of the big nut at the base of the injector. The engine was running and the fuel at the top of the nut was foaming/ bubbling from what I assume was escaping compression. Hope this represents a clearer cartoon. If its a quick fix Ill snatch them out and replace an oring or copper washer. If its not going to cause serious problems I can take time to decide to upgrade or not.
Thanks in advance, Carl
 

·
Registered
Joined
·
225 Posts
Discussion Starter · #5 ·
Thanks Dilbert, I was hoping it would be something simple.
Carl
 
1 - 3 of 3 Posts
Top