Cummins 4BT & Diesel Conversions Forums banner
Cancel

NV4500 input shaft housing

Jump to Latest Follow
1 - 4 of 4 Posts
M

· Registered
Joined
·
1,472 Posts
Discussion Starter · #1 ·
Hello,
Is there supposed to be a gasket between the input shaft housing and the transmission housing? I'm asking because I suppose this will greatly affect the clearance of the bearings.
Thanks,
Mikel
 
Save Share
Reply Quote
M

· Registered
Joined
·
1,472 Posts
Discussion Starter · #3 ·
Thank you. Mine has a bit of drag on 1st gear (only) and I wasn't sure if this could have been caused by me using RTV.
 
Save Share
Reply Quote
M

· Registered
Joined
·
1,472 Posts
Discussion Starter · #4 ·
Found my problem. One of the springs in 1st gear synchro assy had come out. Luckily I was able to fish it and put it back. Not it turns nicely :)
 
Save Share
Reply Quote
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
About this Discussion
3 Replies
2 Participants
Last post:
Mikel
Cummins 4BT & Diesel Conversions Forums
A forum community dedicated to Cummins 4BT Diesel owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, engine swaps, transfer cases, and more!
Full Forum Listing
Explore Our Forums
General Discussion Buildup Showcase Threads - All Engines, Vehicles Performance Discussion Transmission, Adapter, Transfercase Discussion Isuzu 4BD1T/2T
Top