Cummins 4BT & Diesel Conversions Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
393 Posts
Discussion Starter #1
My engine has a oil fill on the driver side of the block...it's missing the cap and I can't seem to locate a part number for it. Does anyone have a part number or a picture of one?? The spout is not threaded, so I assume that it just takes some form of press fit plug??

Thanks in advance for any input.

Mike
 

·
Administrator
Joined
·
4,164 Posts
That cap is actually an expandable rubber stopper. It has a wing nut on the outside that pulls on a bolt with a tapered washer that is on the inside. Best bet would be to remove the oil filler tube and take it to your local Case or John Deere farm tractor supply and see if they can match it up. I have a part number noted but I'm not sure if it's correct - 101322.
 

Attachments

·
Registered
Joined
·
393 Posts
Discussion Starter #3
Thanks Bob! I actually ended up using a rubber expansion plug for pool plumbing. I will hunt down one of those that you have. I just wanted to make sure it wasn't some kind of breather cap.
 
1 - 3 of 3 Posts
Top