Cummins 4BT & Diesel Conversions Forums banner

Source for ZF shift lever?

6K views 5 replies 6 participants last post by  Jimbo 
I just fabricated my own. A little 1/2" cold roll, welded a plate on the bottom to bolt to the stub out of the tranny, weld on threads at the top, some finish sanding, a little paint,voila! A shifter that is the perfect length and is bent just right for my truck.:D
Carl
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top