Cummins 4BT & Diesel Conversions Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,366 Posts
Discussion Starter · #1 ·
Hello,
There have been many comments regarding the importance of properly orienting the turbo's oil inlet/outlets. While looking at the best way to install my HY35, I downloaded the turbo's service manual, and I noticed that both the compressor and exhaust housings can be indexed from the central housing. If this is correct (and other than messing up the wastegate actuator linkage angles), one could align the oil inlet/outlet to an ideal vertical position, and having the compressor's outlet point to the most favorable angle for the instalation. Is this correct, or am I missing something?

Thanks,
Mikel
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top